Frigidaire Dishwasher Repair

Dishwasher Repair, Done Right the First Time

When a Frigidaire dishwasher leaves water in the tub, stops mid-cycle or starts leaving grit on the glasses, the fault usually sits in the drain path, the wash system or the door latch — each of which can be tested on its own.

Frigidaire dishwashers range from basic built-in models to Gallery units with features such as a rotating OrbitClean spray arm on some models. Whatever the trim level, the same systems do the work: a filter and drain pump that remove the water, a wash pump and spray arms that move it, a heating element or heater circuit, and a door latch that tells the control it is safe to start.

Most calls we get are about standing water, poor cleaning or leaks. We check the filter and drain path first, then test the pump, the water inlet valve, the heating circuit and the door latch as needed. Leaks get extra attention, because the source — a door gasket, a loose hose connection or a pump seal — decides whether the fix is small or larger.

Common Dishwasher Problems

01

Water left in the bottom of the tub after the cycle

02

Dishes coming out gritty, cloudy, or still dirty

03

Cycle stopping early, or the start button doing nothing

04

Leak under the door or beneath the unit

05

Detergent pod or powder not dissolving

06

Grinding or humming noise while it drains

Dishwasher Error Codes

Recognize a code on your display? Look it up before you unplug anything or attempt a repair.

See all Error Codes →

Popular Frigidaire Dishwasher Models

Why Trust Us With Your Frigidaire Dishwasher

  • Tested, Not Guessed | We test the suspected dishwasher part before recommending a replacement.
  • Parts for Popular Models | Common dishwasher parts for popular Frigidaire models travel with our technicians; less common parts are ordered and the return visit is scheduled.
  • Safety Comes First | Power, water and gas are shut off before we work on your dishwasher, and high-voltage parts are handled only by the technician.
  • Warranty-Aware Advice | If your dishwasher may still be under manufacturer coverage, we tell you so you can check that option first.
FAQ

Dishwasher Repair FAQ

Turn the dishwasher off and let it cool. Then remove and rinse the filter assembly at the bottom of the tub the way your owner's manual shows. If water still stays in the tub, the drain pump, the drain hose, or the air gap or garbage-disposal connection under the sink needs to be checked by a technician.

A clogged filter, blocked spray arms, water that is not hot enough, or hard water can all cause it. Clean the filter, make sure the spray arms turn freely and use rinse aid. If the film keeps coming back, we test the water fill, the heating and the wash pump.

No. Stop using it. If water keeps appearing, turn off power to the dishwasher at the breaker and close its water supply valve, usually under the sink, before you wipe up. A leak left alone can damage flooring and cabinets.

Need a repair? We're ready to help. Call Now
Call Us Schedule